MILLER CP-250TS TAPPED SLOPE STEEL ALUMINUM 3-PHASE WELDER NO MIG GUN FREE SHIP

This listing is for a MILLER CP-250TS TAPPED SLOPE STEEL ALUMINUM 3-PHASE WELDER NO MIG GUN as can be seen in the pictures.

Condition:

IMPORTANT: Buyer will need to find a MIG gun to fit it. The power pin part of the MIG gun fitting on the feeder is much smaller than the standard Miller power pin size. Tregaskiss used to sell an adapter for this feeder, but we are not sure that they still do.

Unit came from a Federal University lab, unit has been veery well taken care over the years as can be seen in the pictures.

TECHNICAL INFORMATION IN ITALICS BLUE BELOW WAS TAKEN FROM THE WEB:

The CP-250TS was a nice welder in that the "TS" part stands for Tapped-Slope. This means a slope adjustment setting could be changed inside the welder to better suit to different material types, such as steel vs. stainless steel vs. aluminum. The only limiting factor for some folks is that the CP is a 3-phase only power source. It can't be used on single phase.

All of our equipment is fully tested to perform at factory specifications before being shipped.

FREE SHIPPING TO ANY CONTINENTAL USA BUSINESS LOCATION WHERE BUYER CAN UNLOAD IT OFF THE DELIVERY FREIGHT TRUCK!

IF BUYER DOES NOT HAVE THE MEANS TO UNLOAD IT AT DELIVERY (DOESN'T HAVE TWO STRONG GUYS, NO DOCK or FORKLIFT or IF IT IS TO BE DELIVERED AT A RESIDENTIAL ADDRESS) THEN THERE WILL BE A $150 SPECIAL LIFTGATED FREIGHT TRUCK DELIVERY FEE. 

IMPORTANT: SCHOOLS, CHURCHES AND FARMS ARE TECHNICALLY NOT CONSIDERED BUSINESS ADDRESSES BY ALL THE FREIGHT CARRIERS!!!

INTERNATIONAL BUYERS PLS CONTACT US FOR SHIPPING QUOTE!!!

Stock # 241108